Hopefully yesterday saw the conclusion to the saga of my broken laptop.
Two weeks ago I had an attempt at reviving a sickly HP/Compaq 6735S a model which is notorious for GPU problems. Specifically the GPU BGA contacts break due to thermal stresses and shoddy manufacturing.
I had stripped the laptop down and using a IR rework station attempted to reflow the contacts with limited success. It survived one power up and then died again.
The picture above shows the motherboard after I removed it the first time, you can clearly see the GPU in the top right. Notice first the pathetic thermal bonding? Also you can see around all four corners of the chip what appears to be red cement.
Initially I was unsure of whether to remove this and indeed it appeared to be tough and nigh on impossible to remove so fearing possible collateral damage I left the cement in place and heated the GPU on the IR rework station attempting to reflow the joints.
This I believe was the mistake as this bonding would have prevent the chip from floating on the reflowed solder pads. So this time I did remove the cement as you can see below. I found heating the cement did make it malleable, the problem being how to heat it without damaging any of the surrounding components?
In the end I used a precision hot-air gun (which they also have at work) on a low-medium heat setting on a very low ‘blow’ setting. Using this and a couple of wooden toothpicks I was able to remove the vast majority of the red gunk!
Once removed I applied a small amount of flux around the chip, working it under the device and then used the IR rework station but on a much higher setting than before to ensure the solder properly melted.
To my pleasant surprise the reassembled laptop booted and it has been successfully been powered down and rebooted several more times since.
While not the prettiest of laptops, or indeed in the best condition it does at least have Windows 7 Professional on it and a nice big hard drive and 4GB of memory so should prove more than capable for my experiments – assuming she carries on working, and she does get a little warm!